TigerStop Standard Controller 5 User Manual

25
Options Menu
PRint cut
Prints the part length and quantity on the label.
Requires either the Label Printer or Inkjet Printer accessory.
1. Press until reaching the PrintCut screen.
2. Press the [↓] or [↑] soft key to toggle the setting.
inkJet oFFSet
The distance between the inkjet printer and the saw blade.
Requires TigerSaw 1000 or TigerSaw 2000 and an Inkjet Printer accessory.
1. Press until reaching the Inkj O screen.
2. Enter the TigerStop
®
’s password and then press
• By default, the TigerStop
®
’s password is the serial number.
3. Measure the distance between the saw blade and the inkjet printer
head.
4. Enter the measured distance and then press
SaFe zone
Sets the minimum safe distance before issuing a warning to the operator.
Requires TigerFence.
1. Press until reaching the SafeZone screen.
2. Enter the TigerStop
®
’s password and then press
• By default, the TigerStop
®
’s password is the serial number.
3. Enter a distance and then press
Feed HazaRd
Warns the user when the cut length exceeds the outfeed clearance.
1. Press until reaching the FeedHaz screen.
2. Enter the TigerStop
®
’s password and then press
• By default, the TigerStop
®
’s password is the serial number.
3. Enter the outfeed clearance length and then press

TigerStop Standard Controller 5 Specifications

General

Brand	TigerStop
Model	Standard Controller 5
Category	Controller
Language	English