CHASSIS
3 - 4 TimeCutter
Z Service Manual
Installation
Reverse the order of removal. The mower deck, front-
to-rear blade scope, needs to be adjusted, Refer to
“Adjusting the Front-to-Rear Blade Slope” on page 6 -
3.
Side Panel Removal
Left Side Panel Removal
1. Remove the three fasteners holding the rear
portion of the left side panel. Two fasteners are
located in the middle, under the side panel
connecting the panel to the rear support bracket.
The third fastener is located at the rear of the
panel (Figure 11).
Figure 11
mvc-059
2. Remove the two carriage bolts and nuts fastening
the front bracket support to the frame and remove
the bracket (Figure 12).
Figure 12
mvc-060
3. Remove the left side panel off of the frame (Figure
13).
Figure 13
mvc-062
Installation
Follow the removal procedure in reverse.
3
To Next Page
Loading...
Need help?
General
