Toshiba 46PX200 series User Manual

14
Introduction / Getting started
Turning the TV on
Switching on the TV
Connect the power cord to a wall outlet, the !
power indicator lights in red (standby mode).
1 Press 1 on the remote control or ! on the TV
left side panel, the ! power indicator lights in
green.
Note:
If you watch black and white programmes when the
Colour System mode is set to Auto, colour noise
may appear on the screen. In this case select the
appropriate Colour System (For the system of each
country or region, refer to pages 17, 56).
Switching o the TV
1 Press 1 on the remote control or ! on the TV
left side panel to switch to the standby mode.
Notes:
• When the TV will not be used for a long period of
time, such as during vacation or travel, remove the
power plug from the wall outlet.
• If power is cut o while you are viewing the TV,
the Last Mode Memory function turns on the TV
automatically when power is applied again. If power
is going to be o for a long time and you are going
to be away from your TV, unplug the power cord to
prevent the TV from turning on in your absence.
Tuning the TV for the  rst time
Before switching on the TV, put your decoder and
media recorder to standby, if they are connected,
and ensure that the aerial is connected. To setup
the TV, use the buttons on the remote control as
detailed on page 12.
1 Press 1. The Menu Language screen will
appear. This screen will appear the  rst time
that the TV is switched on.
Menu Language
2 Press , ,  or  to select the Menu
Language (English, Chinese (CS), Malay, Thai,
Vietnamese, Russian, Arabic, Persian, French or
Indonesia).
3 Press OK, to display the Location menu
(- page 18).
Press  or  to select Store or Home. For
normal home use, select Home.
Location
Home
To use the TV for displaying in a store showroom,
please select [Store]. [Home] mode is
recommended for normal use.
Store mode:
• A con rmation menu will appear.
• AutoView menu is not available.
4 Press OK to display the AutoView menu
(- page 20).
Press  or  to select Yes or No.
AutoView
No
AutoView mode automatically adjusts picture settings to suit ambient
light conditions. Do you wish to enable AutoView mode?
5 Press OK to display the Auto Signal Booster
menu (- pages 18), and then press  or  to
select Ye s or No.
Auto Signal Booster
Yes
Signal Booster boosts weak analogue broadcast signals.
If you select [Yes], the TV will automatically set this feature
to [On] or [Off] according to signal strength.
Do you wish to enable automatic control?
Yes mode :
This function performs automatic distinction of
On or O .
6 Press OK to display the Auto Tuning startup
screen. Press OK to start the automatic search.
Auto Tuning
Progress
Found
1% 1
7 When the automatic search is completed, the
TV will automatically return to 1 position and
appear the position list on the screen.
Note:
The Quick Setup menu can also be display at any
time from the SETUP menu.
324046PX200SeriesEn.indd14 2012/06/0413:21:46

Toshiba 46PX200 series Specifications

General

Brand	Toshiba
Model	46PX200 series
Category	LED TV
Language	English