User’s Manual 6-15
Power and Power-Up Modes
3. Press Enter.
Power-up modes
The computer has the following power-up modes:
■ Boot: Computer shuts down without saving data. Always save your
work before you turn the computer off in boot mode.
■ Hibernation: Data in memory is saved to the hard disk drive.
■ Standby: Data is maintained in the computer’s memory.
Windows utilities
You can configure various settings associated with both Standby Mode and
Hibernation Mode within TOSHIBA Power Saver.
Hot keys
You can use hot keys Fn + F3 to enter Standby Mode and Fn + F4 to enter
Hibernation. Refer to Chapter 5, The Keyboard, for details.
Panel power on/off
You can set up your computer so that power turns off automatically when
you close the display panel. When you open the panel, power will be turned
on in Standby Mode or Hibernation Mode but not in boot mode.
System Auto Off
This feature turns the system off automatically if it is not used for a set
duration. The system shuts down in Standby Mode or Hibernation Mode in
Windows.
If you enter the password incorrectly three times in a row, the computer
shuts off. In this case, you must turn the computer back on to retry
password entry.
Refer also to the sections Turning on the power and Turning off the power
in Chapter 3, Getting Started.
If the panel power off function is enabled and you manually shut down
Windows, do not close the computer’s LCD display panel until the shut
down process has been completed.
To Next Page
Loading...
Need help?
General