E6582062ï‚‚
6-51 6. [Advanced] How to use parameters
3
4
6
9
When you do not want to pass on the run/stop state and output frequency under the automatic
operation to the manual operation, set <F295> to "0: Disabled".
Reference
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3]
To Next Page
Loading...
Need help?
General