To Next Page

To Previous Page

E6581595

D-11

Default setting 1 ( = )

Setting  to  will return parameters to the standard values that were programmed at the factory.

 When  is set,  is displayed for a short time after the settings are configured, and then

disappears. Then the inverter is in standard motor mode. In this case, the trip history data is cleared.

Trip record clear ( = )

Setting  to  initializes the past four sets of recorded error history data.

 The parameter does not change.

Cumulative operation time clear ( = )

Setting  to  resets the cumulative operation time to the initial value (zero).

Initialization of type information ( = )

Setting typ to  clears the trips when an  format error occurs. But if the  displayed, call us.

Save user setting parameters ( = )

Setting  to  saves the current settings of all parameters. (Refer to section 4.2.7)

Load user setting parameters ( = )

Setting  to  loads parameter settings to (calls up) those saved by setting  to .

(Refer to section 4.2.7)

 By setting  to  or , you can use parameters as your own default parameters.

Cumulative fan operation time record clear ( = )

Setting  to  resets the cumulative operation time to the initial value (zero).

Set this parameter when replacing the cooling fan, and so on

Default setting 2 ( = 1)

Set  to  to return all parameters to their default settings.

When  is set,  is displayed for a short time after the settings are configured, and then

disappears. Then setup menu  is displayed. After reviewing the setup menu items, make a setup

menu selection. In this case, all parameters are returned to their defaults, and the trip history data is cleared.

(Refer to section 3.1.)

Be aware that the following parameters do not return to the standard factory settings even if = is set

for maintainability. (To initialize all parameters, set =.) 

 : Meter selection  : Logic output/pulse train output

  : Meter adjustment gain selection (OUT-NO)

 : Checking the region setting  : Analog output signal selection

 : Analog/logic input selection (VI terminal)  : Inclination characteristic of analog output

 : Sink/source switching  : Analog output bias

 : VI input bias  : Factory specific coefficient 6D

 : VI nput gain  : Free notes

Toshiba TOSVERT VF-nC3 User Manual

Other manuals for Toshiba TOSVERT VF-nC3