E6581611
F-28
6
6.6 Input signal selection
6.6.1 Priority selection (Both F and R are ON)
f105 : Priority selection (Both F and R are ON)
ï‚· Function
This parameter allows you to select the direction in which the motor runs when a forward run (F)
command and a reverse run (R) command are entered simultaneously.
1) Reverse
2) Deceleration stop
[Parameter setting]
Title Function Adjustment range Default setting
f105
Priority selection
(Both F and R are ON)
0: Reverse
1: Deceleration stop
1
(1) [f105 = 0 (Reverse)]: If an F command and an R command are entered simultaneously,
the motor will run in the reverse direction.
Output frequency [Hz]
Forward run
Reverse run
Forward run command
Reverse run command
ON
OFF
ON
OFF
0
Setting frequency
Setting frequency
Time [s]
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
To Next Page
Loading...
Need help?
General