9-2
FISHERMAN SPECIFICATION
■ General
1. The fisherman specification improved in rust prevention as compared with standard vehicles is
provided anew. Please recommend it for such cases shown below.
• For use in marine product industry
• For frequent use on wet ground
• For use in a humid environment
• For transportation of salty or other water tanks involving water splashing onto the vehicle
• For use in an environment where ground surface is constantly wet with salty water
• For use in an environment involving splashing of oxidizing fluid (such as hydrogen peroxide or
sodium hypochlorite)
• For use in an environment where a snow-melting agent such as calcium chloride is used
2. Since the fisherman specification has poorer heat radiation because of the waterproof structures of the
drive and pump motors, the rate of operation should be kept at about 60% compared to standard
vehicles.
Depending on the type of operation (such as continuous heavily loaded operation), the vehicle
performances may be temporarily reduced for protecting the controllers and motors from overheating.
The motor current limiting function that is activated upon detection of the specified temperature by the
sensor built in each controller or motor causes this. This is not an abnormality. Since an alarm
indication is given on the monitoring display, suspend operation for some time and restart after
disappearance of the alarm indication.
■ Items and contents
The following items have been changed from those on the standard vehicles.
Item Content
Drive/Pump motor Waterproof type
Brake switch Waterproof type
Covers
Under the Front-Protector cover
Tilt cylinder hole cover
Mast
Anti-rust roller
Fully oil charged lift cylinder
Tilt cylinder Tilt cylinder boot
Bolt
Rust preventive treatment
(Covers, Tilt pin)
To Next Page
Loading...
Need help?
General
