5-31
Vehicle Abnormalities Not Stored in Diagnosis Memory
Some abnormalities are not stored in diag memory even when the controller detects it and warn the
operator.
Warning indicators Warning method Displayed code
1
Parking brake ON warning:
Warns if the direction switch is turned to the for-
ward or reverse position and the vehicle travels
when the parking brake is on.
• Indication
Parking brake ON
warning indicator
blinks
•Beep
Short beeps
2
Parking brake OFF warning (OPT):
Warns if the operator vacates the seat without
pulling the parking brake lever. (Warns even when
the key switch is OFF)
•Beep
Short beeps
No display
3
Overdischarge warning (lift interrupt):
Warns if the battery discharge exceeds the level
set by the tuning function. (see page 5-45.)
When the warning is activated, material handling
operation while traveling is disabled.
• Indication
Battery charge indica-
tor blinks
•Beep
Short beeps
4
Return to neutral warning:
Warns if the key switch is turned to ON when the
direction switch is in the forward or reverse posi-
tion.
•Beep
Short beeps
No display
5
Material handling lock (OPT):
When the operator leaves the seat while operat-
ing the mini lever and then sits down again, a
buzzer sounds to warn the operator and the mate-
rial handling operation will be disabled.
•Beep
Short beeps
No display
6
Incomplete matching warning:
(1) Tilt angle sensor at fork in the level position
(2) Tilt angle sensor at the forward tilt restriction
angle
(3) Pressure sensor at no-load state
(4) Tire angle sensor at straight travel position
(5) Lift lever angle sensor at lift lever neutral
position (OPT)
(6) Tilt lever angle sensor at tilt lever neutral
position (OPT)
(7) Attachment 1 lever angle sensor at
attachment 1 lever neutral position (OPT)
(8) Attachment 2 lever angle sensor at
attachment 2 lever neutral position (OPT)
• Indication
Wrench symbol
To Next Page
Loading...
Need help?
General
