1 -10
PREPARATION FOR SEWING
7. Changing the Presser Feet
8. Setting Waste Tray
Before changing the presser feet, switch the machine off.
Not doing so could cause an injury.
1. Raise the presser foot and bring the needle
to its highest position. Press the presser foot
holder button in the direction of the arrow to
release the regular foot.
2. Position the presser foot pin below the groove
in the presser foot holder. Lower the presser
foot lever by pressing the button to set the
presser foot.
Button
Presser foot
Presser foot
holder
Groove
Presser foot
pin
(Optional Accessory)
(1) Insert the right guide 乥 of the waste tray to
the right leg of the overlock machine as
illustrated.
Turn the waste tray in the direction of arrow.
(2) Push the left end of the waste tray in the
direction of arrow.
To Next Page
Loading...
Need help?
General
