1 -11
PREPARATION FOR SEWING
9. Threading
Upper looper threading
Before threading, switch the machine off.
Not doing so could cause an injury.
When threading the machine from the beginning, threading must be carried out in the
following sequence:
First: Upper looper threading
Second: Lower looper threading
Finally: Needle threading
Open front cover and side cover.
Bring the upper looper to its lowest position by
turning hand wheel towards you.
Draw thread from spool and pass it through guide
偋 of the thread stand and then, in order, through
guides 偌到䷼ .
Thread the hole of upper looper 偓 using
tweezers. Cut the thread leaving about 10cm (4")
of spare thread.
To Next Page
Loading...
Need help?
General
