1 -7
PREPARATION FOR SEWING
2. Setting Telescopic Thread Stand
3. Opening the Front Cover and Side Cover
Extend the telescopic thread stand to its full
height, then turn it until the shaft clicks into its
locked position.
Before opening the front cover and side cover, switch the machine off.
Not doing so could cause an injury.
How to Open the Front Cover:
a. Push cover to the right as far as it will go, and
b. Pull cover down towards you.
How to Open Side Cover:
a. Push cover to the left to unlock, and
b. Swing cover back away from you.
How to Close Side Cover:
a. Push cover to the right, and
b. Lock into place.
Setting the Tweezers
Take out the tweezers from accessory box to
set it inside of the front panel.
Front cover
Side cover
Tweezers
To Next Page
Loading...
Need help?
General
