1 -21
FOUR THREAD OVEREDGING STITCH USING 2 NEEDLES
8. How to Adjust Stitch Length
9. Sewing for Curved Seams
Before adjusting the stitch length, switch the machine off.
Not doing so could cause an injury.
The machine is pre-set to a 2.5mm stitch length
for regular seaming and overedging. You may
adjust the stitch length from 1mm (Narrow rolled
hemming) to 4.4mm by one-touch of the stitch
length adjusting lever.
倩 For normal overedging, set the stitch length
from 2.5mm to 4.4mm. A stitch length less
than 2.5mm is used only for rolled hemming.
For a neat and clean finish of curved seams:
For inside curves, guide the fabric gently with
the trimming line of the fabric under the right
front of the presser foot, applying pressure to
the fabric with your left hand, at the same time,
apply a little pressure in the opposite direction
with your right hand as shown.
For outside curves, apply pressure in the
opposite directions of the above.
To Next Page
Loading...
Need help?
General
