RT-SVX49C-EN 5
Introduction for TD-5 Installation Guide
The purpose of this guide is to assist you in installing,
programming, and operating the Tracer™ TD-5 display,
which operates with the ReliaTel™ Controller. This guide
describes how to access the screens and the types of
information that appear on the screens.
The Tracer™ TD-5 display allows you to view data and
make operational changes
on the following types of
appl
ications:
•Voyager™
• Precedent™
Hardware
The Tracer™ TD-5 is a durable touchscreen display that is
designed to operate in both indoor and outdoor
environments. The TD-5 display utilizes a standard 75mm
VESA mounting pattern for installation. Alternatively, it
can be installed with a user-supplied VESA mount.
Power
The Tracer™ TD-5 display is powered by 24 VAC or 24 VDC
and requires 21 VA power, which it receives through a
po
wer cable. The display is typically connected to J10 of
the RTRM Module, but it can also be powered from an
alternate power source.
Communication
RS-485 communication is provided to the TD-5 through
the RTRM J10 connector.
Screen characteristics
The 5-inch WVGA 800 x 480 resolution touch-sensitive
color screen is LED backlit, which enables viewing in poor
light conditions including outdoor usage (with the
exception of direct sunlight).
NOTICE
TD-5 Damage!
TD-5 does NOT have a UV-resistant touchscreen and
must be mounted out of direct sunlight. Failure to
follow instructions could result in TD-5 damage.
Touchscreen Guidelines
The touch screen registers the downward pressure of a
touch. Light, quick, yet deliberate touches are most
effective. Touching with more pressure has no effect.
Recommended tools to use:
•finger
•thumb
• pencil eraser
Do NOT use:
• a screwdriver
•a pen
• a pencil point
• any other sharp or pointed object that might scratch
th
e screen surface
To Next Page
Loading...
Need help?
General
