Reset your controller to factory defaults
Management > Maintenance
You may want to reset your controller to factory defaults if you are encountering
difficulties with your controller and have attempted all other troubleshooting. Before
you reset your controller to defaults, if possible, you should backup your controller
configuration first, see “Backup and restore your controller configuration settings” on
page 15.
There are two methods that can be used to reset your controller to factory defaults.
Reset Button – Located on the rear panel of your controller, see “Product
Hardware Features” on page 2. Use this method if you are encountering
difficulties with accessing your controller management page.
OR
Controller Management Page
1. Log into your controller management page (see “Access you wireless controller
management page” on page 12).
2. Click on Management and click on Maintenance.
3. In the Backup/Restore System Configuration section, click Restore to factory default.
Controller default settings
To Next Page
Loading...
Need help?
General
