115
Maintenance and Adjustment
Headlight Adjustment -
Daytona 675 and 675 R
Each headlight can be adjusted by means of
vertical and horizontal adjustment screws
located on the rear of each headlight.
1. Horizontal adjustment screw (left
hand)
2. Vertical adjustment screw (left hand)
3. Horizontal adjustment screw (right
hand)
4. Vertical adjustment screw (right
hand)
5. Pivot screws (DO NOT adjust these
screws)
Switch the headlight dipped beam on.
Turn the vertical adjustment screws on each
headlight clockwise to raise the beam or
counter-clockwise to lower the beam.
On the right hand headlight turn the
horizontal adjustment screw clockwise to
move the beam to the left or counter-
clockwise to move the beam to the right.
On the left hand headlight turn the
horizontal adjustment screw clockwise to
move the beam to the right or counter-
clockwise to move the beam to the left.
Switch the headlights off when the beam
settings are satisfactory.
1
2
5
3
4
cdmw
Caution
Do not adjust the pivot screws as this will
cause the headlight reflector to become
detached from the pivot screw, leading to
irreparable damage to the headlight.
To Next Page
Loading...
Need help?
General
