86
Maintenance and Adjustment
Chain Free-Movement Adjustment
For Daytona 675 and 675 R, the vertical
movement of the drive chain must be in the
range 24 - 30 mm.
For Street Triple and Street Triple R, the
vertical movement of the drive chain must be
in the range 0.51 - 1.25 in (13 - 32 mm).
1. A d j u s t e r b o l t
2. Adjuster bolt locknut
3. Rear wheel spindle nut
Loosen the wheel spindle nut.
Loosen the locknuts on both the left hand
and right hand chain adjuster bolts.
Moving both adjusters by an equal amount,
turn the adjuster bolts clockwise to increase
chain free-movement and counter-clockwise
to reduce chain free-movement.
When the correct amount of chain free-
movement has been set, push the wheel into
firm contact with the adjuster. Tighten both
adjuster locknuts to 20 lbf ft (27 Nm) and
the rear wheel spindle nut to 81 l b f f t
( 110 N m ) .
Repeat the chain adjustment check. Re-adjust
if necessary.
Check the rear brake effectiveness. Rectify if
necessary.
1
2
cdlf
3
Warning
Operation of the motorcycle with insecure
adjuster locknuts or a loose wheel spindle
may result in impaired stability and
handling of the motorcycle. This impaired
stability and handling may lead to loss of
control or an accident.
Warning
It is dangerous to operate the motorcycle
with defective brakes and you must have
your authorized Triumph dealer take
remedial action before you attempt to ride
the motorcycle again. Failure to take
remedial action may reduce braking
efficiency leading to loss of control or an
accident.
To Next Page
Loading...
Need help?
General
