50
General Information
Rider's Seat
All Models
1. Seat lock (Daytona 675 shown)
The seat lock is located on the left hand side
of the battery tray, in line with the footrest
mounting rail. To remove the seat, insert the
ignition key into the seat lock and turn it
counter-clockwise while pressing down on
the rear of the seat. This will release the seat
from its lock and allow it to be slid rearwards
for complete removal from the motorcycle.
To install the seat, engage the seat's tongue
under the fuel tank and press down at the
rear to engage in the seat lock.
Rear Seat/Seat Cover
Daytona 675 and 675 R only
1. Rear seat fastener
To remove the rear seat cover or rear seat
(where fitted): Remove the fastener located
beneath the padding. This will allow the rear
seat/seat cover to be slid forwards for
complete removal from the motorcycle.
Warning
To prevent detachment of the seat during
riding, after fitting always grasp the seat
and pull firmly upwards. If the seat is not
correctly secured, it will detach from the
lock. A loose or detached seat could cause
loss of motorcycle control and an accident.
1
cdmh
1
cdlp
To Next Page
Loading...
Need help?
General
