HOW TO RIDE THE MOTORCYCLE
118
Tires
High speed operation is hard on tires,
and tires that are in good condition are
crucial to riding safely. Examine their
overall condition, inflate to the correct
pressure (when the tires are cold), and
check the wheel balance. Securely
install the valve caps after checking
tire pressures. Observe the information
given in the Maintenance and
Specification sections on tire checking
and tire safety.
Fuel
Have sufficient fuel for the increased
fuel consumption that will result from
high-speed operation.
Caution
In many countries, the exhaust system
for this model is equipped with a
catalytic converter to help reduce
exhaust emission levels.
The catalytic converter can be
permanently damaged if the
motorcycle is allowed to run out of
fuel or if the fuel level is allowed to get
very low.
Always make sure you have adequate
fuel for your trip.
Engine Oil
Make sure that the engine oil level is
correct. Make sure that the correct
grade and type of oil is used when
topping off.
Final Drive Oil
Make sure that the final drive oil level
is correct. Make sure that the correct
grade and type of oil is used when
topping off.
Coolant
Check that the coolant level is at the
upper level line in the expansion tank.
(Always check the level with the engine
cold.)
Electrical Equipment
Make sure that the headlight, rear/
brake light, turn signals, horn, etc. all
work properly.
Miscellaneous
Visually check that all fasteners are
tight.
To Next Page
Loading...
Need help?
General
