GENERAL INFORMATION
64
Joystick Button
The Joystick is used to operate the
following functions of the instruments:
▼ Up - scroll the menu from the
bottom to the top
▼ Down - scroll the menu from the top
to the bottom
▼ Left - scroll the menu to the left
▼ Right - scroll the menu to the right
▼ Center - press to confirm selection.
Horn Button
When the horn button is pushed, with
the ignition switch turned on, the horn
will sound.
Heated Grips Switch (if equipped)
The heated grips will only heat when
the engine is running.
When the heated grips are switched on,
the heated grips symbol will appear in
the display and the selected heat level
will be shown.
There are three levels of heat: low,
medium and high. This is indicated by
the different colors of the symbols
shown in the display.
1
1. Low heat symbol (yellow)
2. Medium heat symbol (orange)
3. High heat symbol (red)
For maximum benefit in cold conditions,
from the OFF position press the switch
once for the high heat setting initially
and then reduce the heat level by
pressing the switch again for a low heat
setting when the grips have warmed up.
To turn off the heated grips, press and
release the switch until the heated
grips symbol is no longer shown in the
display.
Low Power Voltage Cut Off
If a low voltage is detected, the heated
grips will power off. The heated grips
will not function again until the voltage
rises to a safe level.
The heated grips will not power back on
automatically even if the voltage rises to
the safe level. The heated grips switch
must be manually pressed again to
activate the heated grips.
Fog Lights Switch (if equipped)
The fog lights switch will only operate
when the headlights are on. The fog
lights switch will reset to off when the
ignition is turned off then on again.
To turn the fog lights on or off, make
sure that the headlights are on and
then press and release the fog lights
switch. When the fog lights are turned
on, the fog lights indicator will illuminate
in the display.
High Beam Button
The high beam button has a different
function depending on whether Daytime
Running Lights (DRL) are installed or
not. When the high beam is turned
on, the high beam indicator light will
illuminate in the display.
To Next Page
Loading...
Need help?
General
