GENERAL INFORMATION
73
For full details of the TC disabled
warning light operation and its
associated instrument warning
messages, see page 36.
Traction Control Settings
Warning
If the traction control is disabled, the
motorcycle will handle as normal but
without traction control.
In this situation accelerating too hard
on wet/slippery road surfaces may
cause the rear wheel to slip, and may
result in loss of motorcycle control and
an accident.
The TC system can be disabled as
described in Bike Setup on page 57, or
set to the conditions described in Riding
Mode Configuration on page 45.
Blind Spot Radar (if equipped)
Warning
The blind spot radar is an aid. It does
not replace the need to be aware of all
situations when riding.
The rider must always maintain a high
level of awareness and concentration
while riding, always use the mirrors
and check the blind spots. The rider
must not rely on the blind spot
radar. The rider must also look over
their shoulder (head check) prior to
overtaking or changing lanes.
The rider is responsible for detecting
all other vehicles, estimating the
distance between them and the
motorcycle, and then maneuvering the
motorcycle in a safe and responsible
way to avoid any collision.
The rider must also obey all speed
limits, observe all road signs and road
markings, and react accordingly to any
environmental influences such as thick
fog, heavy rain, etc.
Operating and riding the motorcycle
safely and correctly is always the
rider's sole responsibility.
When riding, there is an area behind the
motorcycle and rider that is not always
visible to the rider even when using the
mirrors. This is referred to as a blind
spot area.
The blind spot radar may assist the
rider by monitoring the blind spot areas
behind the motorcycle.
The blind spot radar system can only be
enabled and disabled manually by the
rider.
To Next Page
Loading...
Need help?
General
