GENERAL INFORMATION
57
Settings - Traction Control
The Traction Control (TC) system can
be temporarily disabled. The Traction
Control system cannot be permanently
disabled, it will be automatically enabled
when the ignition is turned off and then
on again.
To enable/disable the traction control:
▼ From the Settings menu, push the
joystick down/up to select the
Traction Control option.
▼ Push the joystick right to move the
slider dot to the right to enable
traction control.
▼ Push the joystick left to move
the slider dot to the left to disable
traction control.
For more information on traction
control, see page 71.
Settings - Triumph Shift Assist
Triumph Shift Assist (TSA) triggers a
momentary engine torque change to
allow gears to engage, without closure
of the throttle or operation of the
clutch. This feature works for both up-
shifts and down-shifts of gear.
The clutch must be used for stopping
and pulling away.
Triumph Shift Assist will not operate if
the clutch is applied or if an up-shift is
attempted by mistake when in 6th gear.
It is necessary to use a positive pedal
force to make sure there is a smooth
gear shift.
To enable/disable Triumph Shift Assist:
▼ From the Settings menu, push the
joystick down/up to select the
Triumph Shift Assist option.
▼ Push the joystick right to move the
slider dot to the right to enable
Triumph Shift Assist.
▼ Push the joystick left to move
the slider dot to the left to disable
Triumph Shift Assist.
For more information on Triumph Shift
Assist, see page 107.
Settings - Hill Hold
Hill hold control assists in making hill
starts. The system (when activated)
will apply the rear brake to hold the
motorcycle in position. The system
will then automatically deactivate and
release the rear brake when it detects
that the motorcycle is attempting to
move off.
To enable or disable the hill hold control:
▼ From the Settings menu, push the
joystick down/up to select the Hill
Hold option.
▼ Push the joystick right to move the
slider dot to the right to enable hill
hold control.
▼ Push the joystick left to move the
slider dot to the left to disable hill
hold control.
For more information on hill hold
control, see page 114.
Settings - Blind Spot Radar
The blind spot radar assists the rider by
monitoring the blind spot areas behind
the motorcycle.
The blind spot radar system can only be
enabled and disabled manually by the
rider.
To Next Page
Loading...
Need help?
General
