General Information
42
If traction control is switched off:
• The TC indicator light will not
illuminate. Instead the TC disabled
warning light will be illuminated.
Note
Traction control will not function if there
is a malfunction with the ABS system.
The warning lights for the ABS, traction
control and the MIL will be illuminated.
Traction Control (TC) Disabled
Warning Light
The TC disabled warning light
should not illuminate unless
traction control is switched
off or there is a malfunction.
If the warning light becomes illuminated
at any other time while riding, it
indicates that the traction control
system has a malfunction that requires
investigation.
Turn Signals
When the turn signal switch is
turned to the left or right, the
indicator warning light will
flash on and off at the same
speed as the turn signals.
Hazard Warning Lights Switch
To turn the hazard warning lights on
or off, press and release the hazard
warning light switch.
The ignition must be ON for the hazard
warning lights to function.
The hazard warning lights will remain
on if the ignition is OFF, until the hazard
warning light switch is pressed again.
High Beam Light
When the high beam button is
pressed the high beam will be
switched on. Each press of
the button will swap between
dip and high beam.
Note
If daytime running lights are installed on
the motorcycle, the high beam button
has additional functionality.
If the DRL switch is in the daytime
running lights position, then press and
hold the high beam button to turn the
high beam on. It will remain on as long
as the button is held in and will turn off
as soon as the button is released.
Note
A lighting on/off switch is not installed
on this model. The tail light and license
plate light all function automatically
when the ignition is on.
The headlight will function when the
ignition is on. The headlight will go off
while pressing the starter button until
the engine starts.
Daytime Running Lights (DRL) (if
equipped)
When the ignition is switched
ON and the daytime running
lights switch is set to Daytime
Running Lights, the daytime
running lights warning light will
illuminate.
The daytime running lights and low
beam headlights are operated manually
using a switch on the left hand switch
housing, see page 42.
To Next Page
Loading...
Need help?
General
