TSC TTP-343 Plus Programming Manual

TSC AUTO ID Technology Co., Ltd. 198 Copyright 2013 All Rights Reserved.
 GETSENSOR()
Description
This command is used to get the sensor status/AD value. We can use it to check the sensor function.
Syntax
GETSENSOR(sensor$[,intension])
Parameter
Description
sensor$
Sensor type.
GAP
Gap sensor
BLINE
Black mark sensor
RIBBON
Ribbon-end sensor
PEEL
Peeler sensor
HEAD UP
Thermal print head open sensor
HEAD TEMP
The temperature of print head
HEAD VOLT
The voltage of print head
intension
Sensor intension.
Gap intension
Please refer to SET GAP for gap
sensor range of different model.
BLINE intension
Please refer to SET GAP for black
mark sensor range of different
model.
RIBBON intension
0 ~ 3
PEEL sensor intension
Ignored
HEAD UP sensor
intension
Ignored
HEAD TEMP
Ignored
HEAD VOLT
Ignored
Returned value
Gap
Return the AD value of gap sensor
BLINE
Return the AD value of black mark sensor
RIBBON
Return the AD value of ribbon sensor
PEEL
The return value will be either 0 or 1
0: Paper is not on the sensor
1: Paper is on the sensor
HEAD UP
The return value will be either 0 or 1
0: print head module is close
1: print head module is open
HEAD TEMP
Return the temperature of thermal print
head
HEAD VOLT
Return the voltage of thermal print head
Note:
This command has been supported since V6.75 EZ and later firmware.

TSC TTP-343 Plus Specifications

General

Brand	TSC
Model	TTP-343 Plus
Category	Printer
Language	English