Operate the shuttle shift only while seated on the tractor.
Do not use the shuttle shift lever to start the tractor for towing or traveling uphill, use
the clutch instead.
Always stop the tractor before getting off.
Caution
►
►►
► MAIN GEAR LEVER
This lever can be shifted by using the clutch, both
when the tractor is stationary or mobile.
It is located on the RH of the driver seat.
1.Press clutch pedal fully before operating shuttle shift lever.
2.When changing from forward to reverse or back to forward again while in high
range make sure the tractor comes to a stop before changing direction. Failure to do
so is likely to result in damage to the mechanism and place the driver at risk of injury.
important
►
►►
► SHUTTLE SHIFT LEVER
This control allows shifting from forward to reverse &
reverse to forward. When stationary set the lever to N for neutral
① Push the lever away from the driver engages forward.
② Pulling the lever towards the driver engages reverse.
39
It is located on the RH of the driver seat.
►
►►
► SUB GEAR LEVER (LINEAR SHIFT LEVER)
Operate the sub gear lever using clutch to select the
appropriate speed for different applications.
It is located on the LHS of driver seat.
Avoid damage!
Select the proper speed range and gear for the job.
• The machine maybe operated in any gear with engine speeds at 950-2600 rpm.
Within these limits, the engine can be placed under varying load operations.
• Never overload engine by lugging machine at low idle speeds.
• Raise engine speed the match expected loads. If a slight increase engine rpm occurs
simultaneously with moving hand throttle lever forward, the engine is not
overloaded.
important
Main gear lever Sub gear lever (Linear shift lever)
To Next Page
Loading...
Need help?
General
