VENTILATION
The ventilation unit is housed in the cab ceiling.
To switch it on and adjust it, turn the electrical fan switch to the desired speed.
The cab becomes slightly pressurized when the ventilation system is in operation, so that the fresh
air can enter only by way of the filter installed in the rear section of the cab roof.
The fan switch can be operated only after the ignition key is inserted.
The air flow can be regulated and directed by suitable positioning the air diffusers.
Air can be taken in fresh from outside or recirculated from within the cab by way of the relative
side inlets
■ Re-circulation inlets fully closed:
Air is taken in entirely from outside the cab through the rear grille and filtered through a paper
element positioned behind the grille.
N.B-it is very important that the air diffusers never be completed closed so as to allow for a steady
air flow.
To obtain a greater pressurization inside the cab, it is necessary to take the air from the outside,
therefore the inside air recirculatiing grille should be fully closed.
■ Working lamp switch
The front and rear working lights are ON when
push the button.The work light indicator lamp on
■ Wiper control switch
- Switch ON
The Wiper switch is ON when Push the Top button.
The Washer switch is ON when Push the Mid-button.
- Switch OFF
Once again push the buttons.
■ Windscreen Washer tank
Check the level of windscreen washer fluid in the
plastic reservoir located at the front of the radiator
During winter,it is advisable to add a suitable antifreeze
or methyl alcohol to the windscreen washer fluid.
■ Interior Lamp
Push the button to light on
And push it again to light off
83
To Next Page
Loading...
Need help?
General
