►
►►
► CHANGING OIL IN THE FRONT AXLE
1. Drain the oil from the center diff plug and the drain
plug in each drive.
2. Replace and tighten all drain plugs.
3.Remove the top plug(Vent plug)from each final drive to
vent air from final drives.
4. Remove the dip stick from the filter hole and fill with
2.64 US gal (10 liters) and allow time for the oil to
drain into the final drives.
5. Check the oil level with the dipstick and replace the
vent plugs on both final drives and tighten
Some operators have found that when they fill with the correct amount of oil and dip
it,the oil level on the dipstick is too high due to the fact that it takes a while for the
oil to run into the final drives.
important
68
CLEANING AND CHANGING FILTERS
►
►►
► ENGINE OIL FILTER
Using a filter wrench turn the filter anti clockwise to
remove it. Lightly smear the rubber seal on the new
filter with oil to ensure, turn it clockwise until the seal
contacts the base and then turn it another 2/3 turn to
tighten it.
To Next Page
Loading...
Need help?
General
