Ubee Interactive Connecting Devices to the Network
Ubee EVW32C Advanced Wireless Voice Gateway Subscriber User Manual • March 2017 15
To mount the EVW32C on a wall:
1. Install the two screws horizontally on a wall 132mm apart. See the figure below.
The screws should protrude from the wall so that you can fit the device between the
head of the screw and the wall. If you install the screws in drywall, use hollow wall
anchors to ensure the unit does not pull away from the wall due to prolonged strain
from the cable and power connectors.
2. Mount the device on the wall.
2.2 Connecting Devices to the Network
Use the instructions below to connect network devices and validate device functionality.
See the following:
Connecting an Ethernet Device on page 15
Connecting a Wireless Device on page 16
Connecting a Telephone Line on page 17
2.2.1 Connecting an Ethernet Device
You can connect up to three additional Ethernet devices to the EVW32C.
To connect another Ethernet device to the network:
1. Connect an Ethernet cable from the Ethernet device (for example, a PC or gaming
console) to an open ETHERNET port on the back of the EVW32C.
2. Use the device LEDs to confirm operations. Refer to Understanding LED Behavior on
page 6 for more information.
3. Open a Web browser and go to any Web site to validate network/Internet connectivity
(for example, http://www.wikipedia.org).
4. If the connected device is a gaming console, perform any online task supported by the
console (for example, log into the gaming server, play an online game, download
content).
To Next Page
Loading...
Need help?
General
