UPO2000CS series User Manual
70
• Press the CURSOR key to enter the cursor measurement menu, then press F1 to select the type as
voltage.
• Press F2 to select the source for channel’s voltage measurement, and set the pattern to independent
The multipurpose knob can be used to adjust the horizontal cursor AY on the screen, press the multipurpose
knob to switch to cursor BY. The value of BY-AY is the voltage measurement (V).
When the setting is set to trace mode with the F3 key, the multipurpose knob can adjust both AY and BY at the
same time.
On the upper left corner of the display area, BY and AY are represented by the current position of the cursor
BY and AY respectively. BY-AY indicates the voltage difference between the two cursors.
To Next Page
Loading...
Need help?
General
