UPO2000CS series User Manual
74
Chapter 11 Auxiliary Function Setting
Press the UTILITY key to enter the auxiliary function settings menu.
Auxiliary function setting menu (the first page)
Functions Options Descriptions
Self-correcting Start self-correcting function
System Info
Displays oscilloscope model number, software
version, firmware version, etc
Language Displays menu language of oscilloscope
Menu Display
1s、2s、5s、10s、20s、
Meanual
Set the menu to auto hide after a specified time, or
manually using MENU key
Press MENU key to recall hidden menu
1/3 Enters Auxiliary function setting menu (2)
Auxiliary function settings menu (2)
Functions Options Descriptions
Waveform
Recording
Enters Waveform Recording Menu
Pass Test Enters Pass Test Menu
Square
Wave
Output
10Hz、100Hz、1kHz、
10kHz
Set the probe compensation signal output frequency, the
default is 1kHz (range = 3V, cannot be changed)
Frequency
Meter
Off Turn off frequency meter function
On Turn on frequency meter function
2/3 Enters Auxiliary function setting menu (3)
Note: The frequency meter is a counter for trigger events. The frequency meter is valid for edge or pulse width, but
not for trigger source.
Auxiliary function settings menu (3)
Functions Options Descriptions
System
Upgrade
Enters oscilloscope software update
Backlight
Brightness
10%~100%
Use the multipurpose knob to select backlight brightness,
from 10%~100%
Output
Selection
Trigger
Set the PASS/FAIL output terminal behind the oscilloscope
to trigger
Pass Test
Set the PASS/FAIL output terminal behind the oscilloscope
to pass test
3/3 Enters Auxiliary function setting main menu
To Next Page
Loading...
Need help?
General
