90 More functions/services
Controlling relays (only for HiPath 3000)
If this function has been configured (contact your service personnel), you can
use up to four relays to enable/disable different devices (such
as a door opener).
Depending on how you program the relays, you can activate and deactivate
them manually them or configure them to activate and deactivate automatically
(after timeout).
Select and confirm the option shown,
or
select and confirm the option shown.
1 ... 4 Enter the relay.
Sensors (HiPath 33x0/35x0 only)
If configured (contact your service personnel), sensors are able to recognize sig-
nals, call your phone, and display an appropriate message on the screen.
Paging persons
(not for USA, not for HiPath 500)
If radio paging equipment (PSE) is connected to your system (contact your ser-
vice personnel), you can locate people via their pocket receivers.
Pocket receivers signal a call request to the person you want to page. This per-
son can then answer the page at the nearest phone.
Paging persons
To ensure that you can be found, you must have enabled a ringing group
Page 100, call forwarding Page 37 or call forwarding-no answer (service
technician) to the internal station number of your PSE.
A call request is signaled automatically.
Answering the page from the nearest telephone
^ Lift the handset.
)59 Enter the code.
j Enter own station number.
Special features must be taken into consideration if your telephone oper-
ates with HiPath 5000 (system networking via PC network) Page 107!
To Next Page
Loading...
Need help?
General