Table 3-4 Parameter – Non Movement Alarm
Parameters Operating Mode Value Range Standard Value
Activation BM/AM/PNG On/off On
Response Time
BM/AM 10 ... 900 s 90 s
PNG 10 ... 90 s 90 s
Prealarm Time
BM/AM 0 ... 300 s 15 s
PNG 0 ... 30 s 15 s
Alarm Destination
BM -
1
1 The alarm destination is the same in Basic Mode of the M3 Plus for all alarms and is entered under "General Settings".
112
AM/PNG (up to 32 digits) (blank)
SHB_PNG-Konfig.fm
A31003-M2000-M103-2-76A9, 07/2014
Alarm and Emergency Call Configuration, Administrator Documentation
3-8
Configuration and activation
Configuration menu
8. Confirm with Save.
Man Down Alarm
The Man Down Alarm can be activated optionally. It is triggered if the sensors identify undue
tilting of the handset over a defined configurable period of time (i.e. deviation from the vertical
position).
For more information on alarm destinations please refer to Chapter 4, "Control ports and alarm
destinations".
Procedure:
1. Select the Additional Features icon in the main menu.
2. Select Configuration.
3. Enter the five-position service PIN and confirm with OK.
4. Select one of the three operating modes.
5. Select Alarms.
6. Select Man Down Alarm.
7. Change the values of the following parameters:
Parameters Operating Mode Value Range Standard Value
Activation BM/AM/PNG On/off On
Table 3-5 Parameter – Man Down Alarm
To Next Page
Loading...
Need help?
General
