Unitech MS832 User Manual

23
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
LED – Good Read
The LED indicator can be programmed On or Off in response to a good read. Default = On.
Number of Beeps – Good Read
The number of beeps of a good read can be programmed from 1 - 9. The same number of
beeps will be applied to the beeper and LED in response to a good read. For example, if you
program this option to have five beeps, there will be five beeps and five LED flashes in
response to a good read. The beeps and LED flashes are in sync with one another. To change
the number of beeps, scan the bar code below and then scan a digit (1-9) bar code and the
Save bar code on the Programming Chart inside the back cover of this manual. Default = 1.
Number of Beeps – Error
The number of beeps and LED flashes emitted by the scanner for a bad read or error can be
programmed from 1 - 9. For example, if you program this option to have five error beeps, there
will be five error beeps and five LED flashes in response to an error. To change the number of
error beeps, scan the bar code below and then scan a digit (1-9) bar code and the Save bar
code on the Programming Chart inside the back cover of this manual.
Default = 1.

Unitech MS832 Specifications

General

Brand	Unitech
Model	MS832
Category	Barcode Reader
Language	English