38
Copyright 2014 unitech Electronics Co., Ltd. All rights reserved. Unitech is a registered trademark of unitech Electronics Co., Ltd.
Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed between
the transmission of each character of scanned data. Scan the Intercharacter Delay bar code
below, then scan the number of 5ms delays, and the Save bar code using the Programming
Chart inside the back cover of this manual.
To remove this delay, scan the Intercharacter Delay bar code, then set the number of delays
to 0. Scan the Save bar code using the Programming Chart inside the back cover of this
manual.
Note: Intercharacter delays are not supported in USB serial emulation.
User Specified Intercharacter Delay
An intercharacter delay of up to 5000 milliseconds (in 5ms increments) may be placed after the
transmission of a particular character of scanned data. Scan the Delay Length bar code below,
then scan the number of 5ms delays, and the Save bar code using the Programming Chart
inside the back cover of this manual.
Next, scan the Character to Trigger Delay bar code, then the 2-digit hex value for the ASCII
character that will trigger the delay ASCII Conversion Chart (Code Page 1252), beginning on
page 115.
To remove this delay, scan the Delay Length bar code, and set the number of delays to 0.
Scan the Save bar code using the Programming Chart inside the back cover of this manual.
To Next Page
Loading...
Need help?
General
