Universal Remote Control URC-A6 User Manual

Page | 20
STEP4: Save your work. After you have
input your five channels, Press the
CHANNEL UP [CH▲] button to store the
commands entered. The CABLE/SAT
Component light will blink three times to
confirm the set-up.
Set up “My Favorite” buttons as Automated
Activity Macros
If you don’t want to program every Favorite
button as a favorite channel or list, you can
set up remaining buttons to send a series of
commands to the components that you
already set up. Our favorite macro is
turning “My Favorite” button D into a
“Watch a Loud Movie” command, so that
you can press one button to turn on the
DVD, TV and Audio system. Then all you
have to do is put in the DVD, hit play, and
turn up the volume. No more juggling
multiple remotes and trying to remember all
the commands.
Here’s how you can set that up.
STEP1:Write down the sequence of events
you desire on a piece of paper. For
instance: Turn off Cable/Sat, Turn on TV,
Set TV Input to DVD, Turn on DVD, Turn on
AUD, set AUD Input to DVD. (Your steps may
vary up to a maximum of 20 activities). You
might want to do a dry run to make sure you
have all the activities in order.
STEP2: Press and hold the button D.
STEP3: Press and hold the MUTE button for
three seconds.
STEP4:Input all steps of the actions that
you wrote down in step one. For instance,
press Cable/Sat, press power off, press TV,
press power on, change TV input to DVD,
press AUD, press power on, etc.
STEP 5: Save your work. After you have
input your commands, Press the CHANNEL
UP [CH▲] button to store this series of
commands as an automated activity macro.
The [DVD] Component light will blink three
times to confirm the set-up.
TV input button not working right?
You may
want to teach your new URC-A6 remote from
your TV remote.
See page 13 for the
Learning Method.

Universal Remote Control URC-A6 Specifications

General

Brand	Universal Remote Control
Model	URC-A6
Category	Remote Control
Language	English