Page | 33
Finding a Component’s
Set-up Code Number
If you used the Auto—Search or Learning
Methods to program a component, you may
not know the code number you
programmed. Here is a way for you to
identify what that code number is, so you
can make a note in the back of this Manual
for future reference.
STEP1: Press the component button you
would like to verify and the SELECT [SEL]
button at the same time for two seconds until
the selected Component light turns on.
STEP2: Press the [INFO] button and count
the number of times the Component LED light
blinks. This number indicates the first digit of
the code. Next, it will pause for about one
second and begin blinking again to indicate
the number of the second digit. Then once
again it will pause, then blink, to indicate
the number of the third digit.
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step
one.
Example:
One blink, pause, eight blinks,
pause, three blinks indicates code number
183. Note that ten (10) blinks represent the
number 0.
Replace
with
high
quality
image
To Next Page
Loading...
Need help?
General
