Universal Remote Control URC-A6 User Manual

Page | 24
ChannelControlPunchThrough
This punch through lets you set up the URC-
A6 remote so that either the Cable or TV
Channel Controls (CHANNEL UP, DOWN,
LAST, CHANNEL NUMBERS 0-9, +10 and
ENTER) will operate in other component
modes on the remote control.
STEP1: Press and hold the component
button you want to add channel control to,
such as [DVD] or [VCR], and the SELECT
[SEL] button at the same time for two
seconds until the Component light turns on.
Release the buttons.
STEP2: Press the CHANNEL UP [CH▲]
button. The component LED light will blink
once.
STEP3: Press either the [TV] or CABLE/SAT]
button that you want to use as the source of
channel control. The component light will
blink three times to confirm it is saved.
Note: If you do not press a button within 30
seconds, the component light will turn off.
The remote will exit the programming mode,
and you will have to start over with step
one.
Replace
with
high
quality
image

Universal Remote Control URC-A6 Specifications

General

Brand	Universal Remote Control
Model	URC-A6
Category	Remote Control
Language	English