Page | 8
1. Quick Set-up
Set-up one component at a time, and you’ll
move quickly through your system.
Step1: Turn on the component you want to
activate. (Other components can be on or
off, it doesn’t matter.)
Step2: Point your new URC-A6 universal
remote toward the component and press the
appropriately labeled Component button (TV
for TV, DVD for DVD, etc.)
While holding
this button down
, press the numeric keys one
at a time sequentially (1, 2, 3, …) until the
component turns off.
Step3: Release the component button to
save the code. The component light will
blink three times to confirm that the code has
been stored.
Check your work
Press the POWER [ON]
button to turn the component back on.
Next, test the VOLUME and CHANNEL
buttons (or PLAY and STOP buttons for VCR
and DVD) to make sure they all work.
Repeat steps one through three until all your
components are set up properly.
Replace
with
high
quality
image
To Next Page
Loading...
Need help?
General
