Valtra Q Series User Manual

PTO
You can use the power take-off (PTO) to transmit
power from the tractor to an implement.
1.
Start the engine and tap the PTO symbol on the SmartTouch
screen to open the PTO settings.
2.
Select the PTO speed. The value stays even in memory when
you turn the ignition off.
3.
You can control the start and stop of the PTO with the switches
on the armrest.
Push the switch down and pull it back to start the PTO.
To stop the PTO, push the PTO switch down and forward.
TIP: You can program PTO start and stop to M1, M2 or M3 buttons
as single operation or as a part of headland management
(U-Pilot) sequence.
PTO Cruise: when activated you can get correct PTO speed
automatically with press of engine speed memory button,
see next page.
1
2
3
The front PTO and the rear PTO can engage in stationary mode.
Procedure
1. Park the tractor and apply the parking brake. The PTO must be in
operation to engage stationary mode.
2. To operate the PTO in stationary mode, push and hold the front
PTO or the rear PTO switch for 3 seconds.
VALTRA EXPERT TIP – STATIONARY USE
27
Q Series Quick Guide

Valtra Q Series Specifications

General

Brand	Valtra
Model	Q Series
Category	Tractor
Language	English