With the automatic power take-off (auto PTO), you
can set the limits for the automatic start and stop
of the PTO. You can give a different limit for when
you lift the rear linkage or lower the rear linkage.
The auto PTO controls the start and stop of the
PTO in these conditions:
• auto PTO is engaged
• rear PTO is in operation
• ground speed PTO (GSPTO) is not engaged
• rear hitch is in the working mode or the oating mode
• driving speed is at least 1 kmh
• headland management is not used.
1.
Open the PTO rear screen.
2.
Engage the auto PTO with the auto PTO switch
on the SmartTouch display.
3.
Set the limit when the PTO starts
when you lower the linkage.
4.
Set the limit when the PTO stops
when you lift the linkage.
AUTO PTO
1
2
3
4
Note that in most cases it is easier to create an U-Pilot Sequence
(Headland managment) for your task.
VALTRA EXPERT TIP
Q Series Quick Guide
28
To Next Page
Loading...
Need help?
General
