Use this checklist together with the initial configuration procedures in the NetBackup
Hardware Installation and Configuration Guide. That document also contains a copy
of this checklist.
For a new appliance, use the following tables to record the initial configuration
settings for this appliance. If this appliance is ever factory reset or re-imaged, the
appliance must be configured again. The recorded settings in the checklist can
save valuable time and help get the appliance back on line quickly.
When using the hard copy or printed version of this checklist, make sure to place
the completed checklist in a secure location. You can also obtain a PDF version of
the checklist to download and save to a location of your choice. To access the latest
version of this checklist, see the following link:
www.symantec.com/docs/DOC6675
Table 1-4
Network Configuration - Create Bond
SettingField
Network Interface
Bond Mode
IP Address
Subnet Mask
Table 1-5
Network Configuration - Tag VLAN
SettingField
Select Interface
Description (for Select Interface field above)
VLAN Id
IP Address (IPv4 or IPv6)
Subnet Mask
Table 1-6
Network Configuration - Add Static Route
SettingField
Destination IP
Destination Subnet Mask
26Preparing for initial configuration
NetBackup appliance initial configuration checklist
To Next Page
Loading...
Need help?
General
