Post configuration
procedures
This chapter includes the following topics:
■ About NIC1 (eth0) port usage on NetBackup appliances
■ Downloading NetBackup client packages to a client from a NetBackup appliance
■ Downloading the NetBackup Administration Console to a Windows computer
from a NetBackup appliance
About NIC1 (eth0) port usage on NetBackup
appliances
By default, NIC1 (eth0) is factory set to IP address 192.168.229.233. This private
network address is reserved to provide a direct connection from a laptop to perform
the initial configuration. NIC1 (eth0) is typically not connected to your network
environment.
Once the initial configuration has been completed, you can connect NIC1 (eth0) to
an administrative network that does not provide any backup data transfer. However,
you may need to change the default IP address if your primary network uses the
same IP address range. NetBackup appliances do not support the use of any
network configuration in the same range as the default IP address for the
administrator interface on NIC1 (eth0).
For example, if NIC2 (eth1) is set to the 192.168.x.x IP address range, you must
change the default IP address of NIC1 (eth0) to a different IP address range.
To change the IP address for NIC1 (eth0) after the initial configuration has been
completed, do one of the following:
3
Chapter
To Next Page
Loading...
Need help?
General
