VERITAS NetBackup 5230 User Manual

3
If a firewall exists between the master server and the media server, open the
following ports on the master server to allow communication with the media
server:
Note: You must be logged in as the administrator to change port settings.
■ vnetd: 13724
■ bprd: 13720
■ PBX: 1556
■ If the master server is a NetBackup appliance that uses TCP, open the
following ports:
443, 5900, and 7578.
4
Make sure that the date and time of the media server matches the date and
time on the master server. You can use an NTP server or set the time manually.
See “Performing the initial configuration on a NetBackup 52xx appliance from the
NetBackup Appliance Web Console ” on page 31.
See “Performing the initial configuration on a 52xx media server appliance from the
NetBackup Appliance Shell Menu” on page 59.
Performing the initial configuration on a 52xx
media server appliance from the NetBackup
Appliance Shell Menu
After you have installed, connected, and turned on all appliance system components,
you are ready to configure the server.
If you plan to configure this appliance as a media server, you must complete the
following tasks on the master server before you start the initial configuration. The
following link provides specific instructions about how to accomplish the necessary
tasks:
See “Configuring a master server to communicate with an appliance media server”
on page 57.
■ Make sure that the master server and this media server have compatible software
versions.
■ Add the name of this media server to the master server that you plan to use
with it.
59Initial configuration procedures
Performing the initial configuration on a 52xx media server appliance from the NetBackup Appliance Shell
Menu

VERITAS NetBackup 5230 Specifications

General

Language version	-
License type	Corporate
License quantity	- license(s)
License term in years	1 year(s)