Programming the immobilizer system
Below is described the procedure to follow for programming the PIAGGIO IMMOBIL-
ISER system and/or for storing other key codes.
Procedure start-brown key
Insert the brown key into the ignition switch (in the «OFF» position), turning it to the
«ON» position. After 1 - 3 seconds, turn the key to «OFF » again and pull it out.
Intermediate step-blu key
After extracting the brown key, insert the blue key within 10 seconds and promptly turn
it to «ON». After 1 - 3 seconds, turn the key to «OFF» again and pull it out.
In this way, a maximum of 3 blue keys can be programmed by repeating the above
procedure and keeping the indicated times.
Final step-brown key
After extracting the last blue key, insert the brown key again and turn it to «ON» (carry
out this operation within 10 seconds after extracting the previous key). Leave it in this
position for 1 to 3 seconds and return it to «OFF».
Proper programming check
Insert the brown key, disabling the transponder (i.e., by tilting the key hood by 90°),
and turn the key to the «ON» position. Perform the engine starter operation. Ensure
that the engine does not start. Insert the blue key and repeat the start-up operation.
Check that engine starts.
22
To Next Page
Loading...
Need help?
General