10.2 Safety and hazard warnings attached to the scalacombi
The labels attached to the scalacombi indicate the following:
Operate the scalacombi only, if the adjustment knob of the handlebar [16] is screwed
into the standpipe [15] and the adjustment knob [13] is screwed into the drive unit [6].
These knobs must be tightened to ensure that the handlebar [18] is firmly attached to
the drive of the scalacombi.
Before operating the stair climber on your own, carefully read all instructions in this
manual.
The scalacombi must only be operated by persons who have participated in the instruc-
tion session provided by the specialist dealer or an agent of Ulrich Alber GmbH.
During the instruction session provided by your specialist dealer or an agent of Ulrich
Alber GmbH, ensure that you are properly informed of all the functions of the scalacombi
and its operation as a stair climber. In addition, test the device by climbing a staircase
without a passenger to familiarise yourself with its operating behaviour.
11. Care and cleaning instructions, safety inspections (maintenance), reuse and disposal
Before carrying out any cleaning or maintenance work, disconnect the spiral cable of the handlebar from the drive unit. To do this, hold
the release sleeve of the adapter [12] and pull the adapter from the socket [11] on the control unit (see also chapter 7.1).
11.1 Care and cleaning instructions
The drive wheels [5] and the internal gear system of the brakes [4] of your scalacombi must be regularly cleaned with spirit to ensure opti-
mum brake effect. If the scalacombi is used on a daily basis, you should clean these parts once every week. If the stair climber is used less
frequently, monthly cleaning might be sufficient. During the safety inspection, which must be carried out at least every 2 years, the drive
wheels and the brakes are tested and worn parts are replaced, if necessary. All other components can be cleaned with a mild conventional
household detergent.
Clean the scalacombi only with a moist cloth.
Ensure that liquid or moisture do not penetrate the stair climber.
11.2 Safety inspections (maintenance)
Your scalacombi is a low-maintenance device. Nevertheless, you should check all attachment and accessory parts at regular intervals to
ensure that they are firmly seated and secured. Latest every 2 years, you must have your scalacombi examined by an expert (technical
safety inspection) to check its performance and safety. During these inspections, defects, wear and fatigue damage that is not otherwise
visible might be detected. To arrange a safety inspection, contact your authorized dealer.
With the exception of the batteries, the two tyres and the brakes, most parts of the drive are not subject to significant wear. To properly
transfer the drive and brake force of the scalacombi, the wheels must have an adequate tread pattern (no cracks) and the brakes must be
operated with sufficient brake force.
All maintenance and repair work on the scalacombi must be carried out by Ulrich Alber GmbH or one of its
authorised specialist dealers. If you encounter any problems with your scalacombi, contact your specialist dealer.
GA_S34_GB.indd 19 16.02.2011 10:45:07
To Next Page
Loading...
Need help?
General
