Fuel Injected Models
21181
1. Move the control handle to the NEUTRAL detent
position.
2. Turn the ignition switch to START II and hold, for
no longer than ten seconds or until engine starts.
If the engine does not start, let go momentarily,
then try again.
3. As soon as engine starts, release key to ON or
RUN I.
Starting the Engine (Warm Start)
All Models
1. Move the control handle to the NEUTRAL detent
position.
2. Turn the ignition switch to START II and hold, for
no longer than ten seconds or until engine starts.
If the engine does not start, let go momentarily,
then try again.
3. As soon as engine starts, release key to ON or
RUN I.
NOTICE! Never leave the key in the ON I position with
the engine not running. Never turn the key to START
II when the engine is running. Either situation could
damage the engine.
NOTICE! If the engine floods during a warm start, sim-
ply follow the directions provided in the following sec-
tion to restart the engine.
Starting
28 47700385 05-2009
To Next Page
Loading...
Need help?
General
