Water in Bellows
OceanX (OXi) drives are equipped with a sensor that
detects water intrusion in the bellows. If water is
detected inside the bellows, an alarm horn will sound
for one second every sixty seconds. If this alarm
sounds, please contact your dealer for repairs as soon
as possible.
Water in Oil and Oil Level
OceanX (OXi) drives are equipped with an oil level
sensor that also detects water intrusion in the drive. If
the oil level in the drive is low or water is detected in
the oil, an alarm horn will sound for one second every
sixty seconds. If this alarm sounds, check the level and
quality of the oil in the drive.
For instructions on checking the level, please refer to
Lubrication System: Checking Engine Oil Level in the
chapter entitled Technical Data. If the oil level is low,
add the necessary amount.
To check the quality of the oil, siphon off a small
amount of oil from the drive. Check to see if the oil has
a milky or translucent white appearance. If the oil has
water in it, it will appear milky.
If the alarm persists after checking the oil level and
quality, please contact your dealer for repairs as soon
as possible.
Oil Sensor Reset
Whenever the drive oil is replaced, the drive oil sensor
must be reset. If your dealer changed the oil in the
drive, the sensor should already have been reset.
However, if you changed the drive oil yourself, or if the
dealer forgot to reset the sensor, the alarm may sound.
If this occurs, you can reset the sensor yourself by
using the following steps:
NOTICE! This procedure must be carried out with the
boat out of the water. If you plan to run the boat while
it is out of the water, ensure that the engine has suffi-
cient cooling water by using the flush port. For addi-
tional information, please see After Engine Shutdown:
Engine Flush in the chapter entitled Engine Shut-
down.
Troubleshooting
62 47700385 05-2009
To Next Page
Loading...
Need help?
General
