VTech IS8151-4 User Manual

7
Install belt clip
To attach the belt clip
Snap the belt clip into the slots on both sides of the cordless
handset.
To remove the belt clip
Lift either of the belt clip tabs outwards from the handset.
Improve the telephone signal strength
N OTE
• To avoid interference, place the telephone base in a central
location of the house and at least 3 feet (1 meter) away from thick
walls as well as other household appliances such as, TV, radio,
microwave oven, Wi-Fi router, large mirror, metal furnture and fish
tank.
> 1 m (3 feet)
> 1 m (3 feet)
> 1 m (3 feet)
TV
Before use
After you install your telephone or power returns following
a power outage and battery depletion, the handset and
telephone base will prompt you to set the date and time, and
to configure the Smart call blocker* and answering system
through voice guide.
Set date and time
N OTE
• Make sure you set the date and time including the year correctly;
otherwise the answering system does not announce the correct
day of the week for your recorded messages time stamp.
1. Use the dialing keys (0-9) to enter the month (MM), date
(DD) and year (YY). Then press NEXT .
2. Use the dialing keys (0-9) to enter the hour (HH) and
minute (MM). Then press q CID or p to choose AM or
PM.
3. Press SAVE to save.
Voice guide for Smart call blocker* / Answering
system
After the date and time setting is done or skipped, the handset
and the telephone base will prompt if you want to set Smart
call blocker. Press YES to start the Smart call blocker setup via
voice guide. For more details, see Voice guide to set Smart call
blocker section. To skip the setup, press NO, or press CANCEL
on the handset or telephone base, and then press OK .
After the Smart call blocker setting is done or skipped, the
handset and the telephone base will then prompt if you
want to set up the answering system. Press YES to start the
answering system setup via voice guide. For more details, see
Voice guide to set Answering system section. To skip the setup,
press NO, or press CANCEL on the handset or telephone base,
and then press OK .
Check for dial tone
Press HOME. If you hear a dial tone, the installation is
successful.
If you do not hear a dial tone:
• Make sure the installation procedures described above are
properly done.
• It may be a wiring problem. If you have changed your
telephone service to digital service from a cable company or
a VoIP service provider, the telephone line may need to be
rewired to allow all existing telephone jacks to work. Contact
your cable/VoIP service provider for more information.
*Includes licenced Qaltel
TM
technology.
Qaltel
TM
is a trademark of Truecall Group Limited.

VTech IS8151-4 Specifications

General

Brand	VTech
Model	IS8151-4
Category	IP Phone
Language	English