Wacker Neuson E3000 User Manual

wc_tx001802gb.fm
117
E 3000 Burner Setup—Oil
Continued from the previous page.
Measuring Measuring the “Z” distance.
a. Place a straight edge over the end of the flame retention head.
b. Adjust the nozzle assembly until the distance between the front face of the
burner nozzle and the end of the flame retention head measures
1-5/8 inches (41 mm). This is the “Z” distance.
c. Tighten the position locking screw (e).
After setting the “Z” distance, complete the procedure.
5. Tighten the knurled nut (b).
6. Mark (x) the escutcheon plate for later reference.
The procedure to set the “Z” distance is now complete.
x

Wacker Neuson E3000 Specifications

General

Brand	Wacker Neuson
Model	E3000
Category	Heater
Language	English