Wacker Neuson E3000 User Manual

wc_tx001803gb.fm
136
Maintenance E 3000
8.3 Repairing a Hose
Requirements  Hose nipple
 Two hose ferrules
 Hose crimping tool, Wacker Neuson part number 5000169002
Procedure Follow the procedure below to repair a damaged hose.
1. Shut down the machine and allow the Heat Transfer Fluid (HTF) to cool.
2. Locate the damaged portion of the hose and clamp locking pliers on either side
of the damaged portion.
3. Cut away the damaged portion of the hose (a) using a utility knife or similar tool.
4. Install a ferrule (b) on each end of the freshly cut hose.
5. Insert a nipple (c) into one of the ferrules.
NOTICE: Do not use petroleum to lubricate the nipple. If lubrication is needed, use
HTF.
6. Insert the free end of the nipple into the second ferrule. Be sure to push each
end of each hose to the lip of the nipple.
This procedure continues on the next page.

Wacker Neuson E3000 Specifications

General

Brand	Wacker Neuson
Model	E3000
Category	Heater
Language	English